In case the tutorial about cleaning the windshield washer's nozzles so it can spray correctly failed for you, the next thing you can do is replace the buggering bit.
The video here shows how you can replace the washer nozzle of an older generation Corolla, year model 1992 and over. The job is even simpler than cleaning the tiny holes with a needle and all you need is a pair of pliers along with the spare part of course.
To reach the nozzle's mounting point you first need to open the hood and remove any heat/noise insulating material underneath it.
Next, locate the nozzle and remove the thin rubber hose attached to it. Now take the pliers and squish the nozzle's anchoring flaps. With your free hand push it out through the hood at the same time.
To put the new nozzle in, clean the hole a bit and just push the new part through the hood until it clicks. Don't forget to attach the hose and put back any insulating materials you took out.
This is a DIY guide and, as such, you must be aware the procedures described here involve some risks. autoevolution cannot be held responsible for any possible damage that might result while following this guide.
Google News