autoevolution

Segment: ATV/Quad

This model is powered by a 4-valve, air-cooled, 4-stroke, 401cc engine, placing it in the midsize displacement class (400cc - 600cc class).

The 8.6:1 compression ratio is 14% lower than the average utility Side by Side. A higher compression ratio is desirable because it means an engine can do the same amount of work with less fuel, leading to increased efficiency and power for a given engine size; high compression ratios are indicative of high performance.

Its carbureted fuel delivery system ensures a lower maintenance engine than one with EFI, but this simplicity comes at the cost of lower efficiency and higher emissions.

KAWASAKI MULE SX 4x4 SE 2017 - Present 21 Photos
KAWASAKI MULE SX 4x4 SE (2017 - Present)KAWASAKI MULE SX 4x4 SE (2017 - Present)KAWASAKI MULE SX 4x4 SE (2017 - Present)KAWASAKI MULE SX 4x4 SE (2017 - Present)KAWASAKI MULE SX 4x4 SE (2017 - Present)KAWASAKI MULE SX 4x4 SE (2017 - Present)KAWASAKI MULE SX 4x4 SE (2017 - Present)KAWASAKI MULE SX 4x4 SE (2017 - Present)KAWASAKI MULE SX 4x4 SE (2017 - Present)KAWASAKI MULE SX 4x4 SE (2017 - Present)KAWASAKI MULE SX 4x4 SE (2017 - Present)KAWASAKI MULE SX 4x4 SE (2017 - Present)KAWASAKI MULE SX 4x4 SE (2017 - Present)KAWASAKI MULE SX 4x4 SE (2017 - Present)KAWASAKI MULE SX 4x4 SE (2017 - Present)KAWASAKI MULE SX 4x4 SE (2017 - Present)KAWASAKI MULE SX 4x4 SE (2017 - Present)KAWASAKI MULE SX 4x4 SE (2017 - Present)KAWASAKI MULE SX 4x4 SE (2017 - Present)KAWASAKI MULE SX 4x4 SE (2017 - Present)KAWASAKI MULE SX 4x4 SE (2017 - Present)

KAWASAKI MULE SX 4x4 SE 401

engine specs
Type
Single cylinder, 4-stroke, Air-cooled
Displacement
401 cm3
Bore X Stroke
3.2x3.0 in OR 81 mm
Compression Ratio
8.6:1
Horsepower
-/- KW(hp)/RPM
Torque
21.7/2400 lb-ft/RPM OR 29/2400 Nm/RPM
Fuel System
arburetor
transmission specs
Gearbox
2-speed, automatic, reverse
Clutch
-
Primary Drive
-
Final Drive
Shaft-driven selectable 4-wheel drive, dual-mode rear differential
chassis specs
Frame
Steel tube ladder type
Front Suspension
MacPherson strut
Rear Suspension
Unit swing axle
Front Brake
Hydraulic drum L&R
Rear Brake
Hydraulic drum L&R
dimension specs
Overall Length
106.7 in OR 2710 mm
Overall Width
52.6 in OR 1336 mm
Seat Height
-
Weelbase
70.1 in OR 1781 mm
Ground Clearance
6.7 in OR 170 mm
Weight
1041 lbs OR 472 kg
Fuel Capacity
4.2 gallons OR 15.9 L
tyres specs
Front
24x9-10 Duro bias
Rear
24x11-10 Duro bias
power system specs
Power pack
-
Nominal Capacity
-
Maximum Capacity
-
Charger type
-
Charging time (normal)
-
Charging time (quick)
-
Range
-

Notice

 
Roll Over Protective Structure (ROPS): Structure meets ROPS requirements for wheeled tractors under SAE J1194, 7.1.1, 7.1.2, and 7.5 and meets the FMVSS 216 Roof Crush resistance requirement
  report a mistake on this page