← Back to: "How to Buy and Install Parking Sensors "
How your bumper should look like
"...You start the measurement from the bumper’s one end to the other. Mark on the duct tape the half of the distance. Then draw the first two sensors location at about 200-250 mm (7-10 inches) in left and right considering the middle point as a landmark. After that you can draw the remaining sensors by drawing at a distance of 400-450 mm(15-17 inches) in the exterior of the previously draw sensors. Don’t mount them too far from the corner point of the bumper, as the sen..." Continue Reading →
Photo credits: diytrade.com
Showing picture: #3/3